Highly productive with seven cutting edges – OptiMill-Uni-HPC-Finish and OptiMill-PM-Trochoid

Product of RSK Persian Rah Soo Kav Co.

  • Hall A A5-B4

Contact Us

Personal information

Please enter your first name.
Please enter your last name.
* required

Your request

Please enter a message.

Send message

Your request has been sent successfully.
Send another message.

Tehran
P.O. Box: 1474746517
1474746517
Iran

Phone / Fax: show
Phone: +98 21 448 989 11
Fax: +98 21 448 989 13
  • Hall A A5-B4

Share link

Recommend

Recommendation of Highly productive with seven cutting edges – OptiMill-Uni-HPC-Finish and OptiMill-PM-Trochoid

Divide various addresses by comma. The recipients will get a link to this platform.

Please enter a valid recipient.
Please enter a valid email address.
Please enter a message.
* required
Your recommendation has been sent successfully.
Send another message.

Product description

The new milling cutters made from solid carbide, the OptiMill-Uni-HPC-Finish and the OptiMill-PM-Trochoid with seven cutting edges, impress with the highest levels of precision and incredible productivity. The increased number of teeth enables higher overall feed rates: production time is reduced and productivity rises significantly. At the same time, the use of a new cutting material substrate greatly enhances tool life.
 
For trochoidal milling of steel, cast steel, and stainless steel MAPAL extends its product range with the addition of the OptiMill-PM-Trochoid with seven cutting edges. Thus, thin walled components can be reliably machined with the highest precision while, at the same time, the machine tool is protected. Roughing close to the contour is also possible without any problems. The lengths of the new cutting edges allow maximum material removal rates of up to 5xD.
 
The new finishing end milling cutter OptiMill-Uni-HPC-Finish with seven cutting edges achieves the highest surface finishes in little time. With a stable core diameter, the tool’s rigidity is greatly increased and any slipping of the tool is avoided. Which means that even with material removal rates of up to 5xD, the highest surface finishes are reliably achieved.
 
The new milling cutters are available in diameters 4 mm to 25 mm in designs of 2xD, 3xD, 4xD and 5xD.